#LASERDRW MAKE CHANGES TO COMPUTER INSTALL#
#LASERDRW MAKE CHANGES TO COMPUTER UPDATE#

When I say skewed Picture a skull made out of clay and some one put there hands on the top of the skull and the bottom and twisted it Whole thing is skewed a little just enough that i noticed it and I just cant let it go to the customer this way. I was machining a skull at a shallow depth (think of a relief carving wrapped around a cylinder) and i noticed that the So I was running a 3d carving file on my rotary axis and well all is good EXCEPT I noticed that it is slightly skewed.

#LASERDRW MAKE CHANGES TO COMPUTER UPDATE#

What or how do I update mach without loosing all my motor tuning, ports and pins, etc stuff. I have plenty of motor power and all that its not mechanical or electrical it is in Mach and has something to do with displaying the run code I believe ( I did change the look ahead from the default to 200 trying to fix something previous could that have done it? Also this computer has plenty of power and memory kernel is set at 60K but could be lowered for the gearing used.

#LASERDRW MAKE CHANGES TO COMPUTER INSTALL#

Ok so this is a fresh install of XP computer and I dont remember what version of Mach is running but its an older one I will try updating it tonight and see if that works. I noticed during the testing that on the program run screen and the MDI screen which also stalls the motors that the box showing what line of code its on is not updating while running when you pause it jumps to the line that it is actually on. So I restarted everything and as soon as I hit the program start button I switched to the settings tab and the whole program almost 1 hour long ran without a single problem. So did some reading here on the forum and tried all kinds of stuff.Дuring the process at one point I let it run stalling its self and went to adjust things and well when I went to the settings tab everything stopped stalling and ran great went back to program run screen and instantly everything starts stalling again switch back to settings tab and runs smooth.

So I loaded up a file that is a 3d relief rastering across instead of around the work (have a small bit of flex in the belt when rastering around the work need to fix) and right off the bat motors stalling and going nuts

Ok so I finally got all my rotary stuff working and I was trying to tweek out the accel and velocity settings and I got everything running a lot faster with no missed steps when I manually jogged everything.

Laserdrw make changes to computer